Orion-system GBD-X Controller Bedienungsanleitung PDF herunterladen (Seite 10)

NET

Address Switch Shown Is

Set For Address 1

Address Switch Shown Is

Set For Address 13

Controller

Address Switch

This Switch Should Be

In The OFF Position

As Shown

Note:

The Power To The Controller Must Be Removed And

Reconnected After Changing The Address Switch

Settings In Order For Any Changes To Take Effect.

Caution

Disconnect All Communication Loop Wiring From The

Controller Before Removing Power From The Controller.

Reconnect Power And Then Reconnect Communication

Loop Wiring.

ADDRESS ADD

The Address For Each Controller

Must Be Unique To The Other Controllers

On The Local Loop And Be Between 1 and 60

FILENAME

DATE:

B. CREWS

DESCRIPTION:

PAGE

DRAWN BY:

OE332-23- GBDX Controller

JOB NAME

OE332-23-GBDX-Wire1A.CDR

FILENAME

JOB NAME

5of5

GBD-X Wiring

4.) All Wiring To Be In Accordance

With Local And National Electrical

Codes And Specifications.

3.) Set-up, Programming And

Monitoring Of The GBD-X

Controller Requires The Use Of A

Personal Computer And Prism

Software.

2.) 24 VAC Must Be Connected

So That All Ground Wires

Remain Common.

Notes:

1.) The GBD-X Can Either Be Used

With CO2 Sensors Or Space

Temperature Sensors But Not

Both On The Same GBD-X

Controller. Up to 2 GBD

Controllers Can Be Located On

Each Local Loop.

AI1

AI1 SET AI2 SET AI3 SET

AI4 SET AI5 SET AI7 SET

AI2

AI3

AI4

AI5

AI7

OE331-21-AVG

GBD Device Wiring

Address Switch Setting Information

10/21/10

1 2 ... 5 6 7 8 9 10 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Orion-system GBD-X Controller Bedienungsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Hardware Orion-system GBD-X Controller