Orion-system MODGAS II Bedienungsanleitung Seite 1

Installation & Operations Manual MODGAS II Controller FACTORY CONTROLS SYSTEM

Section 1 MODGAS II Controller 1-6 Overview and Wiring Warning: Use extreme care not to damage any of the electronic components while mounting the

MODGAS II Controller Section 1 Overview and Wiring 1-7 Board Inputs & Outputs Analog Inputs Input #1 - Heat Enable Contact (HEAT EN) This input

Section 1 MODGAS II Controller 1-8 Overview and Wiring Setting DIP Switches Discharge Air Temperature This switch is only used when the controller

MODGAS II Controller Section 1 Overview and Wiring 1-9 NOTE: It is possible to create a “reverse acting” control sequence by setting the DISCHARGE

Section 1 MODGAS II Controller 1-10 Overview and Wiring

Section 2 Programming Table of Contents Hand Held Service Tool LCD/Keypad Operations... 1 Data Entry Functions...

MODGAS II Controller Section 2 Programming 2-1 Hand Held Service Tool LCD/Keypad Operations Initialization Screen

Section 2 MODGAS II Controller 2-2 Programming Menu Screens After initialization, you will be advanced to the Main Menu screen. All status and setpoi

MODGAS II Controller Section 2 Programming 2-3 Status Screen #2 Change Setpoints MODGAS II Controller Setpoints Accessed from Main Menu Scree

This document is subject to change without notice. WattMaster Controls, Inc. or AAON Inc. do not assume responsibility for errors or

Section 2 MODGAS II Controller 2-4 Programming Setpoint Screen #3 Minimum Default Maximum PID LOOP Period 0 sec. 15 sec. 100 sec. Setpoint Sc

MODGAS II Controller Section 2 Programming 2-5 Summary Screen MODGAS II Controller Summary Accessed from Main Menu Screen #1 – Menu Item #3

Form: WM-MG2-IOM-01C Printed in the USA March 2010All rights reserved Copyright 2010WattMaster Controls Inc. • 8500 NW River Park Drive

Section 1 Overview & Wiring Table of Contents Component Overview... 1 MODGAS II Controller...

MODGAS II Controller Section 1 Overview and Wiring 1-1 Component Overview MODGAS II Controller The MODGAS II Controller is designed to modulate a ga

Section 1 MODGAS II Controller 1-2 Overview and Wiring Figure 1-1: MODGAS II Controller Component Locations Blink Codes for Status LED The MODGAS

MODGAS II Controller Section 1 Overview and Wiring 1-3 Figure 1-2: MODGAS II Controller Dimensions

Section 1 MODGAS II Controller 1-4 Overview and Wiring Supply Air Temperature Sensor The supply air temperature sensor should be located in the duc

MODGAS II Controller Section 1 Overview and Wiring 1-5 Component Wiring MODGAS II Controller Figure 1-4: MODGAS II Controller Wiring The MODGAS